An aeroplane in which the distance between the tips of wings is 50 m is flying horizontally with a speed of 360 km/hr over a place where the vertical component of earth magnetic field is . The potential difference between the tips of wings would be:
1. | 0.1 V | 2. | 1.0 V |
3. | 0.2 V | 4. | 0.01 V |
1. | \(5\) | 2. | \(10\) |
3. | \(15\) | 4. | \(20\) |
The current in a coil varies with time \(t\) as \(I= 3 t^{2} +2t\). If the inductance of coil be \(10\) mH, the value of induced emf at \(t=2~\text{s}\) will be:
1. \(0.14~\text{V}\)
2. \(0.12~\text{V}\)
3. \(0.11~\text{V}\)
4. \(0.13~\text{V}\)
1. | \(0.04\) V | 2. | \(0.4\) V |
3. | \(4\) V | 4. | \(0.004\) V |
The network shown in figure is a part of a complete circuit. If at a certain instant, the current \(i\) is \(10\) A and is increasing at the rate of \(4\times 10^{3}\) A/sec, then \(V_A-V_B\) is:
1. | \(6\) V | 2. | \(-6\) V |
3. | \(10\) V | 4. | \(-10\) V |
A rod \(AB\) of length \(l\) is moving with constant speed \(v\) in a uniform magnetic field on a conducting \(U\)-shaped wire as shown. If the rate of loss of heat energy across resistance \(R\) is \(Q,\) then the force needed parallel to velocity to keep rod moving with constant speed \(v\) is:
1. \(Qv\)
2. \(\dfrac{Q}{v}\)
3. \(\dfrac{Q^2}{v}\)
4. \(Q^2v\)
A coil is wound of a frame of rectangular cross-section. If the linear dimensions of the frame are doubled and the number of turns per unit length of the coil remains the same, then the self inductance increases by a factor of:
1. | \(6\) | 2. | \(12\) |
3. | \(8\) | 4. | \(16\) |
A rectangular loop of wire shown below is coplanar with a long wire carrying current \(I.\)
The loop is pulled to the right as indicated. What are the directions of the induced current in the loop and the magnetic forces on the left and right sides of the loop?
Induced current | Force on left side | Force on right side | |
1. | counterclockwise | to the left | to the right |
2. | clockwise | to the left | to the right |
3. | counterclockwise | to the right | to the left |
4. | clockwise | to the right | to the left |
An electric potential difference will be induced between the ends of the conductor shown in the diagram when the conductor moves in the direction of:
1. \(P\)
2. \(Q\)
3. \(L\)
4. \(M\)