A block A of mass m₁ rests on a horizontal table. A light string connected to it passes over a frictionless pulley at the edge of table and from its other end another block B of mass m₂ is suspended. The coefficient of kinetic friction between the block and the table is  μ_k. When the block A is sliding on the table, the tension in the string is

1. (m₂+μ_km₁)g /(m₁+m₂)

2. (m₂-μ_km₁)g/(m₁+m₂)

3. m₁m₂(1+μ_k)g/(m₁+m₂)

4. m₁m₂(1-μ_k)g/(m₁+m₂)

A plank with a box on it at one end is gradually raised about the other end. As the angle of inclination with the horizontal reaches 30°, the box starts to slip and slides 4.0 m down the plank in 4.0 s. The coefficients of static and kinetic friction between the box and the plank will be. respectively

1. 0.6 and 0.6

2. 0.6 and 0.5

3. 0.5 and 0.6

4. 0.4 and 0.3

Two stones of masses m and 2m are whirled in horizontal circles, the heavier one in a radius r/2 and the lighter one in radius r. The tangential speed of lighter stone is n times that of the value of heavier stone when they experience same centripetal forces. The value of n is

1. 2

2. 3

3. 4

4. 1

A system consists of three masses m₁, m₂ and m₃ connected by a string passing over a pulley P. The mass $m_1$ hangs freely and m₂ and m₃ are on a rough horizontal table (the coefficient of friction=μ) The pulley is frictionless and of negligible mass. The downward acceleration of mass m₁, is (Assume,m₁=m₂=m₃=m)


1. g(1-gμ)/9

2. 2gμ/3

3. g(1-2μ)/3

4. g(1-2μ)/2

Three blocks with masses m, 2m and 3m are connected by strings, as shown in the figure. After an upward force, F is applied on block m, the masses move upward at constant speed v. What is the net force on the block of mass 2m? (g is the acceleration due to gravity)

1. Zero

2. 2mg

3. 3mg

4. 6mg

The upper half of an inclined plane of inclination θ is perfectly smooth while the lower half is rough. A block starting from rest at the top of the plane will again come to rest at the bottom if the coefficient of friction between the block and lower half of the plane is given by

1. μ=1/tanθ

2. μ=2/tanθ

3. μ=2tanθ

4. μ=tanθ

A car of mass 1000 kg negotiates a banked curve of radius 90m on a frictionless road. If the banking angle is $45°$,the speed of the car is 

1. 20 $m{s}^{-1}$                                             2. 30 $m{s}^{-1}$

3. 5 $m{s}^{-1}$                                               4. 10 $m{s}^{-1}$

A car of mass \(m\) is moving on a level circular track of radius \(R\). If \(\mu_s\) represent the static friction between the road and tyres of the car, then the maximum speed of the car in circular motion is given by:

A person of mass 60 kg is inside a lift of mass 940 kg and presses the button on control panel. The lift starts moving upwards with an acceleration $1.0$ $\mathrm{m}/{\mathrm{s}}^2$. If $\mathrm{g}=10$ $\mathrm{m}/{\mathrm{s}}^2$, the tension in the supporting cable is:

1. 9680 N

2. 11000 N

3. 1200 N

4. 8600 N

A body of mass M hits normally a rigid wall with velocity v and bounces back with the same velocity. The impulse experienced by the body is

(1) 1.5 Mv                                                 

(2) 2 Mv

(3) zero                                                     

(4) Mv