A 2V battery is connected across the points A and B as shown in the figure given below. Assuming that the resistance of each diode is zero in forward bias and infinity in reverse bias, the current supplied by the battery when its positive terminal is connected to A is 

(a) 0.2 A
(b) 0.4 A
(c) Zero
(d) 0.1 A

Subtopic:  PN junction |
 84%
From NCERT
To view explanation, please take trial in the course.
NEET 2025 - Target Batch
Hints
To view explanation, please take trial in the course.
NEET 2025 - Target Batch

 In the circuit, if the forward voltage drop for the diode is 0.5V, the current will be 

(a) 3.4 mA
(b) 2 mA
(c) 2.5 mA
(d) 3 mA

Subtopic:  PN junction |
 87%
From NCERT
To view explanation, please take trial in the course.
NEET 2025 - Target Batch
Hints
To view explanation, please take trial in the course.
NEET 2025 - Target Batch

Current in the circuit will be 


(a) 540A
(b) 550A
(c) 510A
(d) 520A

Subtopic:  Applications of PN junction |
 88%
From NCERT
To view explanation, please take trial in the course.
NEET 2025 - Target Batch
Hints
To view explanation, please take trial in the course.
NEET 2025 - Target Batch

advertisementadvertisement

The diode used in the circuit shown in the figure has a constant voltage drop of \(0.5~\text{V}\) at all currents and a maximum power rating of \(100\) milliwatts. What should be the value of the resistor \(R\), connected in series with the diode for obtaining maximum current?


1. \(1.5~\Omega\)
2. \(5~\Omega\)
3. \(6.67~\Omega\)
4. \(200~\Omega\)

Subtopic:  PN junction |
 62%
From NCERT
To view explanation, please take trial in the course.
NEET 2025 - Target Batch
Hints
To view explanation, please take trial in the course.
NEET 2025 - Target Batch

For a transistor amplifier in common emitter configuration for load impedance of 1 kΩ (hfe = 50 and hoe = 25 μA/V) the current gain is 

(a) – 5.2                   (b) – 15.7

(c) – 24.8                  (d) – 48.78

To view explanation, please take trial in the course.
NEET 2025 - Target Batch
Hints

In the following common emitter configuration an NPN transistor with current gain β = 100 is used. The output voltage of the amplifier will be 

(1) 10 mV

(2) 0.1 V

(3) 1.0 V

(4) 10 V

Subtopic:  Transistor (OLD NCERT) |
 67%
From NCERT
To view explanation, please take trial in the course.
NEET 2025 - Target Batch
Hints
To view explanation, please take trial in the course.
NEET 2025 - Target Batch

advertisementadvertisement

A sinusoidal voltage of peak value 200 volts is connected to a diode and resistor R in the circuit shown so that half-wave rectification occurs. If the forward resistance of the diode is negligible compared to R the r.m.s voltage (in volt) across R is approximately

(1) 200                           

(2) 100

(3) 2002                         

(4) 280

Subtopic:  PN junction |
From NCERT
To view explanation, please take trial in the course.
NEET 2025 - Target Batch
Hints
To view explanation, please take trial in the course.
NEET 2025 - Target Batch

The junction diode in the following circuit requires a minimum current of 1 mA to be above the knee point (0.7 V) of its I-V characteristic curve. The voltage across the diode is independent of current above the knee point. If VB = 5 V, then the maximum value of R so that the voltage is above the knee point, will be

(1) 4.3 kΩ                

(2) 860 kΩ

(3) 4.3 Ω                  

(4) 860 Ω

Subtopic:  PN junction |
 80%
From NCERT
To view explanation, please take trial in the course.
NEET 2025 - Target Batch
Hints
To view explanation, please take trial in the course.
NEET 2025 - Target Batch

In the circuit given below, V(t) is the sinusoidal voltage source, voltage drop VAB(t) across the resistance R is

(1) Is half wave rectified

(2) Is full wave rectified

(3) Has the same peak value in the positive and negative half cycles

(4) Has different peak values during positive and negative half cycle

Subtopic:  Applications of PN junction |
From NCERT
To view explanation, please take trial in the course.
NEET 2025 - Target Batch
Hints
To view explanation, please take trial in the course.
NEET 2025 - Target Batch

advertisementadvertisement

The peak voltage in the output of a half-wave diode rectifier fed with a sinusoidal signal without filter is 10 V. The dc component of the output voltage is 
(1)10/2  V                                   

(2) 10/π V

(3) 10 V                                           

(4) 20/π V

Subtopic:  Rectifier |
 55%
From NCERT
To view explanation, please take trial in the course.
NEET 2025 - Target Batch
Hints
To view explanation, please take trial in the course.
NEET 2025 - Target Batch