Consider the situation shown in the figure. The wire AB is sliding on the fixed rails with a constant velocity. If the wire AB is replaced by semicircular wire, the magnitude of the induced current will:

   

1.	increase.
2.	remain the same.
3.	decrease.
4.	increase or decrease depending on whether the semicircle bulges towards the resistance or away from it.

A small square loop of wire of side l is placed inside a large square loop of wire of side L (L > l). The loop are coplanar and their centre coincide. The mutual inductance of the system is proportional to 

(1) l / L

(2) l² / L

(3) L/l

(4) L²/l

A uniform but time-varying magnetic field \(B(t)\) exists in a circular region of radius \(a\) and is directed into the plane of the paper, as shown. The magnitude of the induced electric field at point \(P\) at a distance \(r\) from the centre of the circular region:

1. is zero
2. decreases as \(\frac{1}{r}\)
3. increases as \(r\)
4. decreases as \(\frac{1}{r^2}\)

Two circular coils can be arranged in any of the three situations shown in the figure. Their mutual inductance will be:

A conducting rod of length \(2l\) is rotating with constant angular speed \(\omega\) about its perpendicular bisector. A uniform magnetic field \(\vec {B}\) exists parallel to the axis of rotation. The emf induced between the two ends of the rod is:

1. \(B\omega l^2\)
2. \(\frac{1}{2} B \omega l^{2}\)
3. \(\frac{1}{8} B \omega l^{2}\)
4. zero

As shown in the figure, P and Q are two coaxial conducting loops separated by some distance. When the switch S is closed, a clockwise current I_P flows in P (as seen by E) and an induced current $I_{Q_1}$ flows in Q. The switch remains closed for a long time. When S is opened, a current $I_{Q_2}$ flows in Q. Then the directions of $I_{Q_1}$ and $I_{Q_2}$ (as seen by E) are 

(1) Respectively clockwise and anticlockwise

(2) Both clockwise

(3) Both anticlockwise

(4) Respectively anticlockwise and clockwise

A conducting wireframe is placed in a magnetic field that is directed into the paper. The magnetic field is increasing at a constant rate. The directions of induced current in wires AB and CD are

(1) B to A and D to C

(2) A to B and C to D

(3) A to B and D to C

(4) B to A and C to D

A conductor ABOCD moves along its bisector with a velocity of \(1\) m/s through a perpendicular magnetic field of \(1~\text{wb/m}^2\), as shown in fig. If all the four sides are of \(1\) m length each, then the induced emf between points A and D is:
                  
1. \(0\)

2. \(1.41\) volt

3. \(0.71\) volt

4. None of the above

A conducting rod PQ of length L = 1.0 m is moving with a uniform speed v = 2 m/s in a uniform magnetic field B = 4.0 T directed into the paper. A capacitor of capacity C = 10 μF is connected as shown in figure. Then

(1) q_A = + 80 μC and q_B = – 80 μC

(2) q_A = – 80 μC and q_B = + 80 μC

(3) q_A = 0 = q_B

(4) Charge stored in the capacitor increases exponentially with time