In a surface tension experiment with a capillary tube, water rises upto 0.1 m. If the same experiment is repeated on an artificial satellite, which is revolving around the earth, water will rise in the capillary tube upto a height of-
(1) 0.1 m
(2) 0.2 m
(3) 0.98 m
(4) Full length of the capillary tube
एक केशिकानली के पृष्ठ तनाव प्रयोग में, जल 0.1m तक बढ़ जाता है। यदि यही प्रयोग एक कृत्रिम उपग्रह पर दोहराया जाता है, जो पृथ्वी के चारों ओर घूम रहा है, तो केशिकानली में जल की ऊँचाई कितने तक बढ़ जाएगी?
(a) 0.1m
(b) 0.2 m
(c) 0.98 m
(d) केशिकानली की पूर्ण लंबाई
The amount of work done in blowing a soap bubble such that its diameter increases from d to D is (T= surface tension of the solution)
(a) (b)
(c) (d)
साबुन के एक बुलबुले को ऐसे फुलाया जाये कि उसका व्यास d से D हो जाता है, के लिए किया गया कार्य (T = विलयन का पृष्ठ तनाव)
(a) (b)
(c) (d)
A cylinder of height 20 m is completely filled with water. The velocity of efflux of water (in m/s) through a small hole on the side wall of the cylinder near its bottom is
(a) 10 (b) 20
(c) 25.5 (d) 5
20 मीटर ऊंचाई का एक बेलन पूर्ण रूप से जल से भरा है। उसके तल के समीप बेलन की दीवार पर एक छोटे से छेद के माध्यम से जल का बहिर्वाह वेग (m / s में) है।
(a) 10 (b) 20
(c) 25.5 (d) 5
The Working of an atomizer depends upon
(a) Bernoulli's theorem (b) Boyle's law
(c) Archimedes principle (d) Newton's law of motion
एक कणित्र का कार्य निर्भर करता है
(a) बर्नौली की प्रमेय (b) बॉयल का नियम
(c) आर्किमिडीज सिद्धांत (d) न्यूटन की गति का नियम
Oil spreads over the surface of water whereas water does not spread over the surface of the oil, due to
(a) Surface tension of water is very high
(b) Surface tension of water is very low
(c) Viscosity of oil is high
(d) The viscosity of water is high
तेल जल की सतह पर फैलता है जबकि जल तेल की सतह पर नही फैलता है, इसके कारण
(a) जल का पृष्ठ तनाव बहुत अधिक होता है
(b) जल का पृष्ठ तनाव बहुत कम होती है
(c) तेल की श्यानता अधिक होती है
(d) जल की श्यानता अधिक होती है
A film of water is formed between two straight parallel wires of length 10cm each separated by 0.5 cm. If their separation is increased by 1 mm while still maintaining their parallelism, how much work will have to be done (Surface tension of water =)
(1)
(2)
(3)
(4)
प्रत्येक 10 cm लम्बाई वाले व् 0 .5 cm दूरी से विभाजित सीधे और सामानांतर तारो के मध्य जल की एक फिल्म बनाई जाती है। इनकी सामानांतरता को बनाए रखते हुए यदि इनके विभाजन में 1 mm की वृद्धि कर दी जाए, तब और कितना अधिक कार्य करना पड़ेगा (जल का पृष्ठ तनाव =)
(a) (b)
(c) (d)
A homogeneous solid cylinder of length L(L<H/2) . Cross-sectional area A/5 is immersed such that it floats with its axis vertical at the liquid-liquid interface with length L/4 in the denser liquid as shown in the fig. The lower density liquid is open to atmosphere having pressure . Then density D of solid is given by
(a) (b)
(c) (d)
L(L<H/2) वाले एक ठोस समांगी बेलन का A/5 अनुप्रस्थ काट क्षेत्रफल डूबा हुआ है चूँकि यह अपने अक्ष के ऊर्ध्वाधर तरल -तरल अंतरापृष्ठ के सघन तरल में L/4 लम्बाई तक चित्रानुसार तैरता है। यदि वायुमंडल में खुले तरल का निम्न घनत्व है फिर ठोस का घनत्व D होगा?
(a) (b)
(c) (d)
The surface tension of a liquid at its boiling point
(a) Becomes zero
(b) Becomes infinity
(c) is equal to the value at room temperature
(d) is half to the value at the room temperature
एक तरल का इसके क्वथनांक पर पृष्ठ तनाव
(a) शून्य हो जाता है
(b) अनंत हो जाता है
(c) कमरे के तापमान के मान के बराबर है
(d) कमरे के तापमान के मान का आधा है
The angle of contact between glass and mercury is
(1) 0°
(2) 30°
(3) 90°
(4) 135°
कांच और पारा के बीच स्पर्श कोण है
(a) 0° (b) 30°
(c) 90° (d) 135°
In order to float a ring of area 0.04 in a liquid of surface tension 75 N/m, the required surface energy will be
(a) 3 J (b) 6.5 J
(c) 1.5 J (d) 4 J
0.04 क्षेत्रफल की एक अंगूठी तैरने के क्रम में पृष्ठ तनाव 75 N /m वाले तरल में, आवश्यक पृष्ठीय ऊर्जा होगी
(a) 3 J (b) 6.5 J
(c) 1.5 J (d) 4 J