A wheel is rotating 900 rpm about its axis. When power is cut off it comes to rest in 1 min. The angular retardation in rad/s² is 

1. $\mathrm{\pi }/2$

2. $\mathrm{\pi }/4$

3. $\mathrm{\pi }/6$

4. $\mathrm{\pi }/8$

An automobile engine develops 100 kW when rotating at a speed of 1800 rev/min. What torque does it deliver ?

1. 350 N-m

2. 440 N-m

3. 531 N-m

4. 628 N-m

In an orbital motion, the angular momentum vector is 

1. Along the radius vector

2. Parallel to the linear momentum

3. In the orbital plane

4. Perpendicular to the orbital plane

A wheel is at rest. Its angular velocity increases uniformly and becomes 80 rad/s after 5 s. The total angular displacement is 

1. 800 rad

2. 400 rad

3. 200 rad

4. 100 rad

A force\(- F \hat k\) acts on O, the origin of the coordinate system. The torque at the point (1, -1) will be:

1. $-\mathrm{F}\left(\hat{\mathrm{i}}+\hat{\mathrm{j}}\right)$

2. $\mathrm{F}\left(\hat{\mathrm{i}}+\hat{\mathrm{j}}\right)$

3. $-\mathrm{F}\left(\hat{\mathrm{i}}-\hat{\mathrm{j}}\right)$

4. $\mathrm{F}\left(\hat{\mathrm{i}}-\hat{\mathrm{j}}\right)$

A wheel whose moment of inertia is 12 ${\mathrm{Kgm}}^2$ has an initial angular velocity of 40 rad/sec. A constant torque of 20 Nm acts on the wheel. The time in which the wheel is accelerated to 100 rad/sec is

1.  72 seconds

2.  16 seconds

3.  8 seconds

4.  36 seconds

A constant torque acting on a uniform circular wheel changes its angular momentum from ${\mathrm{A}}_0$ to $4 {\mathrm{A}}_0$ in 4s. The magnitude of this torque is 

1. $\frac{3{\mathrm{A}}_0}{4}$

2. $4 {\mathrm{A}}_0$

3. ${\mathrm{A}}_0$

4. $12 {\mathrm{A}}_0$

A solid cylinder rolls down an inclined plane that has friction sufficient to prevent sliding. The ratio of rotational energy to total kinetic energy is

1.  $\frac{1}{2}$

2.  $\frac{1}{3}$

3.  $\frac{2}{3}$

4.  $\frac{3}{4}$

A swimmer while jumping into water from a height easily forms a loop in the air, if

Assertion : A ladder is more apt to slip when you are high up on it than when you just begin to climb

Reason : At the high point on a ladder, the torque is large and on climbing up the torque is small