A system changes from the state (P1, V1) to (P2, V2) as shown in the figure. What is the work done by the system ?
(1) 7.5 × 105 joule
(2) 7.5 × 105 erg
(3) 12 × 105 joule
(4) 6 × 105 joule
एक निकाय में अवस्था (P1, V1) से (P2, V2) तक परिवर्तन होता है जैसा कि चित्र में दिखाया गया है। निकाय द्वारा किया गया कार्य क्या है?
(1) 7.5 × 105 जूल
(2) 7.5 × 105 अर्ग
(3) 12 × 105 जूल
(4) 6 × 105 जूल
An ideal gas is taken through the cycle A → B → C → A, as shown in the figure. If the net heat supplied to the gas in the cycle is 5 J, the work done by the gas in the process C → A is
(1) – 5 J
(2) – 10 J
(3) – 15 J
(4) – 20 J
एक आदर्श गैस चक्र A → B → C → A के माध्यम से लाया जाता है, जैसा कि चित्र में दिखाया गया है। यदि चक्र में गैस को दी जाने वाली कुल ऊष्मा 5J है। प्रक्रम C → A में गैस द्वारा किया गया कार्य है:
(1) – 5 J
(2) – 10 J
(3) – 15 J
(4) – 20 J
A steam engine delivers 5.4× of work per minute and extracts 3.6× of heat per minute from its boiler. The efficiency of the engine is:
1. 15%
2. 18%
3. 13%
4. 11%
एक भाप इंजन प्रति मिनट 5.4× कार्य करता है और अपने भाप क्वथित्र से 3.6× ऊष्मा प्रति मिनट उत्सर्जित करता है। इंजन की दक्षता है:
1. 15%
2. 18%
3. 13%
4. 11%
P-V plots for two gases during adiabatic process are shown in the figure. Plots 1 and 2 should correspond respectively to -
(1) He and O2
(2) O2 and He
(3) He and Ar
(4) O2 and N2
रुद्धोष्म प्रक्रम के दौरान दो गैसों के लिए P-V आरेख आकृति में दिखाया गया है। आरेख 1 और 2 को क्रमशः निम्न के संगत होना चाहिए -
(1) He और O2
(2) O2 और He
(3) He और Ar
(4) O2 और N2
A cylinder fitted with a piston contains 0.2 moles of air at temperature 27°C. The piston is pushed so slowly that the air within the cylinder remains in thermal equilibrium with the surroundings. Find the approximate work done by the system if the final volume is twice the initial volume
(1) 543 J
(2) 345 J
(3) 453 J
(4) 600 J
एक पिस्टन युक्त बेलन में 27°C ताप पर 0.2 मोल वायु भरी हुई है। पिस्टन को इतनी धीमे से धकेला जाता है कि बेलन के अंदर भरी हुई वायु वातावरण के साथ ऊष्मीय संतुलन में बनी रहती है। निकाय द्वारा किया गया अनुमानित कार्य ज्ञात कीजिए यदि अंतिम आयतन प्रारंभिक आयतन से दोगुना है।
(1) 543 J
(2) 345 J
(3) 453 J
(4) 600 J
A thermodynamic system is taken from state A to B along ACB and is brought back to A along BDA as shown in the PV diagram. The net work done during the complete cycle is given by the area
(1) P1ACBP2P1
(2) ACBB'A'A
(3) ACBDA
(4) ADBB'A'A
जैसा की PV आरेख में दर्शाया गया है, एक ऊष्मागतिकी निकाय अवस्था A से B तक ACB के सापेक्ष ले जाया जाता है और BDA के सापेक्ष A तक वापस लाया जाता है। पूर्ण चक्र के दौरान किया गया कुल कार्य किस क्षेत्रफ़ल द्वारा प्रदर्शित है?
(1) P1ACBP2P1
(2) ACBB'A'A
(3) ACBDA
(4) ADBB'A'A
During an adiabatic process. the pressure of a gas is found to be proportional to the cube of its temperature. The ratio of CP/CV for the gas is
1. 4/3
2. 2
3. 5/3
4. 3/2
एक रुद्धोष्म प्रक्रम के दौरान, गैस का दाब इसके ताप के घन के समानुपाती पाया जाता है। CP/Cv का अनुपात गैस के लिए है:
(a) 4/3
(b) 2
(c) 5/3
(d) 3/2
For the indicator diagram given below to select the wrong statement.
1. Cycle - II is a heat engine cycle
2. Net work is done on the gas in cycle - I
3. Work done is positive for the cycle I
4. Work done is positive for the cycle - II
नीचे दिए गए संकेत आरेख के लिए गलत कथन का चयन कीजिए।
1. चक्र - II एक ऊष्मीय इंजन चक्र है
2. चक्र - I में गैस पर परिणामी कार्य किया जाता है
3. चक्र - I के लिए किया गया कार्य धनात्मक है
4. चक्र - II के लिए किया गया कार्य धनात्मक है
A thermodynamic system is taken through the cycle PQRSP process. The net work done by the system is -
(1) 20 J
(2) – 20 J
(3) 400 J
(4) – 374 J
एक ऊष्मागतिकी निकाय को नीचे दिए गये चक्रीय प्रक्रम के पथ PQRSP के माध्यम से ले जाया जाता है। तो निकाय द्वारा किया गया परिणामी कार्य का मान क्या होगा-
(1) 20 J
(2) – 20 J
(3) 400 J
(4) – 374 J
The second law of thermodynamics states that in a cyclic process
(1) Work can not be converted into heat
(2) Heat can not be converted into work
(3) Work can not be completely converted into heat
(4) Heat can not be completely converted into work
किसी ऊष्मागतिकी निकाय के लिए निम्नलिखित में से कौन सा कथन सही है?
(1) सभी प्रक्रमों में आंतरिक ऊर्जा परिवर्तित होती है
(2) आंतरिक ऊर्जा और एन्ट्रॉपी अवस्था फलन हैं
(3) एन्ट्रापी में परिवर्तन कभी भी शून्य नहीं हो सकता है
(4) रुद्धोष्म प्रक्रिया में किया गया कार्य हमेशा शून्य होता है